Processor help...

Psy · Post by **Psy** » Wed Oct 22, 2003 11:38 am

Muwahahahahahaha

Drive2Survive · Post by **Drive2Survive** » Thu Oct 23, 2003 10:06 am

Will fsaa work on mtm2?

Yep, I run mine with antialiasing all the time.

Fsaa makes it apear as if I'm running a higher resiloution... (I thiknk...) I think its all done in the hardware.... I dunno...

Antialiasing is all about smoothing the jagged lines and edges you often see in computer graphics by blending the pixels. Yeah, it does sorta make it look like it's running in a higher resolution. You're right, it's all done in your graphics hardware. The actual results you get will depend on your graphics card... I have a GF4 that supports four FSAA modes, the highest-quality being 4xS, and I've found that any of the ones below 4xS tend to produce a bit of flicker and artifacts around edges...

Psyc · Post by **Psyc** » Fri Oct 24, 2003 1:26 am

Ive just basicly decided this thing is a waste... dsl is finally makin' its way out here... middle fo december I get to zoom along finaly... I'm hoping to have a comp built by then...