I don't get how this works

APRhc_Andka · Post by **APRhc_Andka** » Wed Nov 22, 2000 5:10 am

Can I have some clear instructions please? The instructions in the thing is too confusing

------------------
APRhc_Andka
ô¿ô ö¿ö ò¿ò
o¿o O¿O 0¿0

Post by **Phineus** » Wed Nov 22, 2000 6:00 am

http://mtm2.com/~mtmg/Binedit/

That's as clear as you're likely to get.

XZ_SIG · Post by **XZ_SIG** » Wed Nov 22, 2000 6:22 am

I use Milkshape to make the models and import them into BinEdit. Its much easier.

------------------
XZ_SIG
Team XZ

APRhc_Andka · Post by **APRhc_Andka** » Wed Nov 22, 2000 8:03 am

Ok...where can I get Milkshape XZ_SIG?

------------------
APRhc_Andka
ô¿ô ö¿ö ò¿ò
o¿o O¿O 0¿0

XZ_SIG · Post by **XZ_SIG** » Thu Nov 23, 2000 2:19 am

Post by **Phineus** » Thu Nov 23, 2000 5:23 am

Go here http://mtm2.com/~mtmg/Binedit/ and in the beyond binedit part are a lot of notes about other 3D programs. Just read it, man.

APRhc_Andka · Post by **APRhc_Andka** » Fri Nov 24, 2000 9:09 pm

ok Phineus

------------------
APRhc_Andka
ô¿ô ö¿ö ò¿ò
o¿o O¿O 0¿0