Problems with height
-
smork428
- Member
- Posts: 20
- Joined: Thu Sep 16, 2004 2:06 pm
- Location: Estonia (Eastern Europe,beside Russia)
Problems with height
Okay, the problem: Im trying to make trucks out of the original MTM2 props (like the old junked out bus)..Ive resized the model to make it the size of a normal truck body,BUT its too low.. I mean the model is correctly sized,but "sinking" in the ground.Could someone tell me what to do? I could probably make better trucks,if I had a solution to this problem.
Kui sa seda vaatad,siis sa oled ajudeta haisev väärakas!
-
ZOtm_BigDOGGe
- Member
- Posts: 881
- Joined: Wed Nov 06, 2002 2:01 pm
- Location: Silicon Valley, California. USA
- Contact:
Load the model into Binedit, and use MODEL/TRANSLATE to raise it up a foot or two or three, then save it again. Repeat until it's where you want it.
TIP: For a reference, turn on SHOW AXES in the VIEW menu. After you do, load BIGFOOT.BIN for a rough idea of how high the bus model should be moved in relation to the axis lines.
TIP: For a reference, turn on SHOW AXES in the VIEW menu. After you do, load BIGFOOT.BIN for a rough idea of how high the bus model should be moved in relation to the axis lines.
--> "Obstacles are those frightful things you see when you take your eyes off your goals." -- Henry Ford