Mapping question

kpayne89 · Post by **kpayne89** » Thu Nov 02, 2006 5:44 pm

i tryed to map couple textures for my dome one by one. i have one face how i want it, but then i gotta map the OTHER side again, its been getting on my nerves mapping it one by one to match the other faces. is there an easier way to do this? i didnt know if there was an option to have one face be mapped like the same as another without doing it by hand each face after face..if u get it. lol

Cale · Post by **Cale** » Thu Nov 02, 2006 7:16 pm

When cycling through the faces press F when you get to each of the two faces you want to map. This is to select multiple faces, and they will turn green. Then choose Groups -> Map Face Group to Texture. Press "Layout" and the faces will be oriented as they are on the model.

kpayne89 · Post by **kpayne89** » Thu Nov 02, 2006 7:33 pm

haha cool, thanks